It's a better, less verbose driver, and also this fixes an occasional crash on boot.
This change introduces the ability to enable or disable the spoken interface/TTS from the on-device settings, either via the UI or the Lua console. This closes out the implementation of issue #245. The TTS setting is only visible in Display settings if voice samples are present in `/.tangara-tts/` on the SD card. Playback of new TTS voice samples is inhibited when TTS is disabled. By default, the setting is enabled, as the device will only play back TTS voices if samples are present on disk. If you need samples to test TTS on your device, feel free to grab the voice samples I have at https://codeberg.org/tursiae/tangara-tts-samples. There's about 80-85% coverage of the UI, with the remainder to be added soonish. Reviewed-on: https://codeberg.org/cool-tech-zone/tangara-fw/pulls/251 Co-authored-by: Tursiae <git@tursiae.org> Co-committed-by: Tursiae <git@tursiae.org>
This should help significantly with https://codeberg.org/cool-tech-zone/tangara-fw/issues/121, which seems to be caused by some SD cards being very picky about being the only SPI device on their bus. Co-authored-by: ailurux <ailuruxx@gmail.com> Reviewed-on: https://codeberg.org/cool-tech-zone/tangara-fw/pulls/176 Co-authored-by: jacqueline <me@jacqueline.id.au> Co-committed-by: jacqueline <me@jacqueline.id.au>
This replaces the previous system of a separate track and queue repeat, with a RepeatMode type with the following options and behaviours: - OFF: No repeat, queue or track. When the current queue finishes, shuffled or otherwise, playback will stop. - REPEAT_TRACK: The current track will loop indefinitely, unless next is explicitly called through some user action (ie using the next button in the now playing screen) - REPEAT_QUEUE: The entire queue will repeat indefinitely. When shuffled is enabled this will repeat the queue with new combinations each cycle. The repeat mode is persisted in non-volatile storage, so the behaviour will be consistent throughout restarts and queue replacements, and so the "queue repeat by default" use case can be met in this way. In addition, I've made it work a little nicer when the queue runs out in the now playing screen, keeping the previously played track shown and playback can be continued by using the play button or by going to a previous song in the queue. Reviewed-on: https://codeberg.org/cool-tech-zone/tangara-fw/pulls/126 Co-authored-by: ailurux <ailuruxx@gmail.com> Co-committed-by: ailurux <ailuruxx@gmail.com>
Previously we were doing it synchronously, which led to some odd looking livelock stacktraces... we still don't have a consistent repro, but this at least makes the stack when we mount a lot more predictable